Specifications
Manufacturer Harman International
Model Number HK 695
Drivers (satellite) Two Odyssey
Drivers (subwoofer) One 5.25 inch woofer
Power (satellite) 6 watts per satellite at 1% THD
Power (subwoofer) 28 watts at 1% THD
Crossover Frequency (subwoofer) 180 Hz
Dimensions
Width:
Satellite 3.5 inches
Subwoofer 11.75 inches
Depth:
Satellite 5.75 inches
Subwoofer 11.75 inches
Height:
Satellite 11.5 inches
Subwoofer 13 inches
Input Impedance 5-10kOhm
Signal-to-Noise ratio >70dB
Frequency Response 35 - 20 kHz
Input Sensitivity 300-400 mV rms for rated
power output
Fuse type Radio Shack 270-1062 or Eqiv.
NOTE: Before replacing fuse, remove AC power
plug from the wall outlet. To replace fuse, twist
fuse cap counterclockwise with a standard
flathead screwdriver. The fuse cap is spring
loaded and will pop out.
USA/Canada Power 120 volts, 60Hz AC
Maximum Power Consumption 120 watts
UL/CUL/CE Approved
Regulatory
FCC Statement and Warning
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by on or more of the following
measures:
a) Re-orient or relocate the receiving antenna.
b) Increase the separation between the equipment and receiver.
c) Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
d) Consult the dealer or an experienced radio/TV technician for help.
MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE
USER AUTHORITY TO OPERATE THE EQUIPMENT UNDER FCC RULES.
Page 14 |
ACEC
